・Remaining margin length too short or disappeared. (UC type)
・No margin part remain through wearing. (UC type)
・No clearance through wearing. (ST type)
A:Smaller hole size
Hole diameter will be below size if the margin part has disappeared.
B:Poor hole quality
Poor chip evacuation caused by a shortened flute length, causes poor registration accuracy and
roughness.
A:Poor hole quality
Increases contact between the drill's surface and the inner hole, worsening accuracy, smear and nail
heading.
B:Smaller hole size
Hole diameter will be below size caused by the worn drill
・Check the margin length, the margin part and clearance at re-pointing.
・Only remove suitable amount during repoint. (Recommended : Over 0.2mm of the margin part should
remain)
*Click here "About re-pointing
amount"
PRODUCT 01 PCB Drills / Routers / Ultra precision micro-hole drill